Working on perfection is always time consuming. I met up with my top pattern makers and seamstress on Friday to go over three of the new suits in the collection. They just did not think they were perfect so the remade the samples. I tried them all on and the first do over was perfect. The second suit which takes time to put on, the design keeps your shaft at full length maybe even stretched a bit while it is incorporated in two separate pouches one for the balls and one for the shaft. Problem was that they look separate and I wanted the two pouches to blend as one. I wanted it to look even right next to the wearer that it was an interesting single pouch. In actuality it is the exact shape as the penis but I wanted the shaft to lay tight against the ball pouch. When we finished it was perfect. I was so happy we got it done. The third was trickier. It is a new design with a built in adjustable cock ring a push out pouch and a micro bikini rear. It looked great but when I got hard the fabric pulled away on top and you could see shaft. At the same time it was pulling in tight against my anus. So we had a perfect looking suit but we needed it to feel great too. One problem is the gold rubberized metal look fabric. Just awesome to look at but hard to work with. The girls had my lay down with my legs up (I just needed the stirrups to complete the picture) I was tired from a late night out and told them to do what they wanted I was going to nap. The suit came off and on about ten times, measuring, tighten the cock strap to different settings, pulling the strap the was rubbing against my hole In and out all while my cock was as hard as it gets there was even a point where I felt like I might have an orgasm, lots of hands playing roughly with my shaft and balls. The pouch looked perfect and the back seemed to be correct. The answer came when they removed the cock strap, than put it on my cock tightly on its own not attached to the suit. My cock was instantly hard and they crammed it back in the suit. The pouch now fit great, it was not pulling away and the rear was just right. As it turns out the cock strap needed to be moved. It was that simple but not visually apparent until the hands on work was completed. The design is just fabulous looking and I can’t wait to get my sample next week and wear it to the beach.
Mens swimwear
2 thoughts on “Getting them right for you! New swimwear designs”
Comments are closed.
Sorry to be so annoying about this issue, but i already sent 2 emails to koala and received no answer (not even a “no, we can’t do it”): now that you are working on a new collection it would be a good timing to consider some of my old regrets/suggestions for some of the suits, namely:
– Feminized suits: could they all have aluminum rings instead of iron? In the beaches i go to they leave rust all over the fabric, rendering the suits useless…
– Inspiration “V” insert; the same suggestion, for the same reason mentioned above.
A while back i suggested to replace all these iron rings or inserts with stainless steel and you said that was not cost effective (i agree), but since i have some of my preferred suits damaged right now, I’m even willing to pay for the extra cost. If it is not possible, i will have to get by without replacing these suits, with great sorrow.
I will check into it. Are you sending your e-mails to [email protected] because I have not received any. I make an effort to answer everyone!!
MD
Yes, i’ve sent two emails to that address, the first one in May 15th this year, followed by a forward of the same email, on June 12th. I also sent the same content to your dregga’s group email (won’t publish it here), on August 3rd. Anyway, in forwarded the original email to Koala Swim’s address right now, maybe you can check it out. Thank you!